Removing Boards From The Des-7210/7206; Steps For Removing Boards - D-Link DES-7200 Hardware Installation Manual

3.14 Removing Boards from the
DES-7210/7206
3.14.1

Steps for Removing Boards

1. Unplug all cables/fibers such as optical fibers and RJ45 twisted pairs from the panel.
2. Tighten two captive screws on the panel.
3. Draw out the board by holding the ejector with both hands, as shown in Figure 3-18 and
Figure 3-20.
Warning
Figure 3-18 Schematic Diagram for the Components of the DES-7210
3-16
1. Always wear an anti-static wrist strap before plugging/unplugging a
board.
2. Do not hold the edge of the PCB or collide the components on the
PCB.
DES-7200 Hardware Installation Guide