Connecting To The Management Port; Logging Onto The Web Manager; Additional Information - D-Link DGS-3420-28SC Quick Installation Manual

Connecting to the Management Port

The front panel of the Switch features a Management portwhich can be used to connect to a computer using
a standard Ethernet cable. A web browser or Telnet client can be used to connect to the Switch using the
MGMT port.
The default IP address of the Management port is 192.168.0.1, and a subnet mask of 255.255.255.0. Make
sure that the computer being used for Switch management has a nonconflicting IP address in the
192.168.0.x subnet.
The IP settings or enabled status of the Management port can be changed through the console port. To
change the configuration of the Management port, use the command:
config out_band_ipif {ipaddress <network_address> | state [enable | disable] | gateway <ipaddr>}
To view the status or IP settings, use the command:
show out_band_ipif
To change settings for the out-of-band Management port in the web interface, use the following path:
Management > Out of Band Management Settings

Logging onto the Web Manager

To access the Web User Interface the user simply runs the standard web browser and enter the Switch's IP
address into the address bar of the browser and press the Enter key. To access the Web UI from normal
LAN ports, the user needs to configure an IP address for this interface first before it can be accessed via the
Web User Interface:
The PC must have an IP address in the same subnet as the switch. For example, if the switch has an IP
address of 10.90.90.90, the PC should have an IP-address of 10.x.y.z (where x/y is a number between
0 ~ 254 and z is a number between 1 ~ 254), and a subnet mask of 255.0.0.0. Open the web browser and
enter 10.90.90.90 (the factory-default IP address) in the address bar. Then press Enter.

Additional Information

For more detailed information on how to set up and configure the DGS-3420-28SC, please refer to the
D-Link Website http://www.dlink.com/.
10