Respironics REMstar Auto M Series system User Manual page 41

p
roblEm
The device's display is
erratic.
Device Resets/Reboots:
The device shuts down
and restarts automati-
cally during therapy.
(This is unlikely to occur.)
The Ramp feature does
not work when you
press the Ramp button
( ).
rEm a m s
star uto ErIEs
W I h
hy t
The device or
power supply has
been dropped
or mishandled,
or the device or
power supply is in
an area with high
Electromagnetic
Interference (EMI)
emissions.
The device comes
installed with
troubleshooting
software that
automatically
monitors perfor-
mance.
Your home care
provider did not
prescribe Ramp
for you, or your
CPAP pressure is
already set to the
minimum setting.
u m
sEr anual
appEnEd
Unplug the device and the power supply.
Reapply power to the device. If the problem
continues, relocate the device to an area with
lower EMI emissions (e.g., away from electronic
equipment such as cellular phones, cordless
phones, computers, TVs, electronic games, hair
dryers, etc.).
If the problem still occurs, contact your home
care provider for assistance.
Such a reset poses no danger to the patient
and assures that the patient receives prescribed
therapy throughout the night. If there is a pos-
sibility of damage to the device, the device will
shut down permanently. The product will then
display the following system error alert to indi-
cate that the device be returned to the home
care provider for service:
If Ramp has not been prescribed for you, dis-
cuss this feature with your home care provider
to see if they will change your prescription.
If your provider has enabled Ramp, but the
feature still does not work, check the pressure
setting on your Active Display screen. If it is set
to the minimum setting (4.0 cm H
feature will not work.
W d
hat to o
Service Required
O), the Ramp
2
5-5