Respironics REMstar Auto M Series system User Manual page 25

C 4: d
haptEr
This chapter explains the therapies available with the REMstar Auto M Series device, how to start
the device, and how to change the settings.
4.1 a
vaIlablE
The REMstar Auto M Series device delivers the following therapies:
• CPAP – Delivers Continuous Positive Airway Pressure; CPAP maintains a constant level of
pressure throughout the breathing cycle. If your health care professional prescribed ramp for
you, you can press the Ramp button to reduce the pressure and then gradually increase the
pressure to the therapeutic pressure setting so that you can fall asleep more comfortably.
• CPAP with C-Flex – Delivers CPAP therapy with pressure relief upon exhalation to improve
patient comfort based on patient needs.
• Auto-CPAP – Delivers CPAP therapy while automatically adjusting the pressure level to
meet the patient's needs.
• Auto-CPAP with C-Flex – Auto-CPAP therapy with pressure relief upon exhalation to
improve patient comfort based on patient needs.
• Auto-CPAP with A-Flex – Auto-CPAP therapy with pressure relief taking place at the end of
inhalation and at the start of exhalation to improve patient comfort based on patient needs.
4.2 s
tartIng
1. Plug the device in to an AC or DC power source. The three primary buttons light up and the
Software Version screen momentarily appears, shown in Figure 4–1.
Note:
Version 1.0 shown in Figure 4–1 is an example. Your device may have a different
software version installed.
2. The next screen to appear is the Standby (or Inactive) screen, shown in Figure 4–2. You can
access the FOSQ questionnaire or patient settings and data from this screen. See Section 4.3
for instructions on how to navigate the display screens.
rEm a m s
star uto ErIEs
o
EvICE pEratIon
t
hErapIEs
d
thE EvICE
f 4–1 s
IgurE
f
IgurE
u m
sEr anual
V 1.0
v s
oftWarE ErsIon
– FOSQ +
Setup
4–2 s s
tandby CrEEn
CrEEn
4-1