Respironics REMstar Auto M Series system User Manual page 33

The Patient Setup screens are described below.
– FOSQ
Setup
C-Flex Setting
1 2 3
C-Flex Setting
FLEX comfort has been
disabled on this unit.
A-Flex Setting
1 2 3
A-Flex Setting
FLEX comfort has been
disabled on this unit.
rEm a m s
star uto ErIEs
1. Standby Screen
The Standby screen appears when you first apply power to the
device. You can access the Patient Setup menu from this screen by
+
pressing the + button. Once inside the Setup menu, press the
or buttons to cycle through the screens.
2. C-Flex Setting Screen
This screen displays the C-Flex level set by your home care
provider. This setting allows you to adjust the level of air pressure
relief that you feel when you exhale during therapy. Your home
care provider will either enable or disable C-Flex.
– If C-Flex is enabled and the setting is not comfortable for
you, you can increase or decrease the setting by pressing
the + or – buttons. The setting of 1 provides a small amount
of pressure relief, with higher numbers providing additional
relief. Press the + or – buttons to increase or decrease the
setting.
– If your provider has disabled C-Flex, you cannot enable
or adjust the setting. The screen shown at left displays to
indicate that C-Flex is disabled.
Note: These screens will only display if your unit is set for
3. A-Flex Setting Screen
This screen displays the A-Flex level set by your home care
provider. This setting allows you to adjust the level of air pressure
relief that you feel when you exhale during therapy. Your home
care provider will either enable or disable C-Flex.
– If A-Flex is enabled and the setting is not comfortable for
you, you can increase or decrease the setting by pressing
the + or – buttons. The setting of 1 provides a small amount
of pressure relief, with higher numbers providing additional
relief. Press the + or – buttons to increase or decrease the
setting.
– If your provider has disabled A-Flex, you cannot enable
or adjust the setting. The screen shown at left displays to
indicate that A-Flex is disabled.
Note: These screens will only display if your unit is set for
u m
sEr anual
C- Flex.
A- Flex.
4-9