Respironics REMstar Auto M Series system User Manual page 34

Ramp Start Pres
4.0 cmH 2 O
Mask Alert
Feature: ON
Auto Off
Feature: ON
After you have finished modifying the Patient Setup screens, press the
Standby screen.
Note:
The Setup menu automatically times out and returns to the Standby screen
after one minute of inactivity.
4-10
4. Ramp Starting Pressure Screen
You can increase or decrease the ramp starting pressure in 0.5 cm
H O increments by pressing the + or – buttons. The default setting
2
is 4 cm H O. You can adjust the setting from 4 cm H
2
pressure setting.
Note: This screen will not display if your provider has not en-
abled Ramp on your device.
5. Mask Alert Screen
You can enable or disable the mask alert setting by pressing the
+ or – buttons to select OFF or ON. If this feature is enabled, the
words Mask Leak appear on the Active display screen when a
significant mask leak is detected, and an audible alert sounds.
Note:
If your physician indicates that the Mask Alert is neces-
sary for you, do not disable it.
6. Auto Off Screen
You can enable this feature if you want the device to automati-
cally turn the airflow off whenever you remove the interface (e.g.,
mask) from your airway.
Press the + or – buttons to select OFF or ON. If this feature is en-
abled, the words Auto Off appear on the Standby screen if the de-
vice detects that you have removed your mask. The airflow shuts
off, and Auto Off continues to appear on the Standby screen until
the condition is corrected.
2
button to return to the
rEm a m s
star uto ErIEs
O to the CPAP
u m
sEr anual