Installing Model 80 Into 80Zc Cabinet - New Buck Corporation 80ZC Operation Maintenance Safety

Zero clearance cabinet for use with fireplace model 80 only

Hide thumbs Also See for 80ZC:

Table of Contents

CONTINUED FRAMING AND INSTALLATION

INSTALLING MODEL 80 INTO 80ZC CABINET

5. Before installing heater into 80ZC you must remove front. Remove (6) six screws, (3) three on each

side of front. Lay front aside for future use. (See Figure 20)

NOTE: Place drop cloth in front of 80ZC opening before installing heater to protect the floor from

damage.

6. Place heater in front of 80ZC cabinet, lift heater up and into 80ZC cabinet onto the heater runners,

slide heater back until it stops against heater stops. .(See Figure 20 and Figure 21)

7. Plug the power cord into receptacle inside lower right side of cabinet. (See Figure 21)

FRONT SCREWS

LEFT SIDE

FIGURE 20

HEATER STOPS

HEATER RUNNER STOPS

FRONT VIEW

80ZC CABINET

FIGURE 21

Page 21

Buck

FRONT SCREWS

RIGHT SIDE

Buck

RECEPTACLE

Table of Contents