Table of Contents
Advertisement
1 Place envelopes in your inserter.
2 Configure in supervisor mode the rates on the mailing system
3 Configure in user mode the postage to be used for the batch of
4 Start metering
Either press
order» from the inserter with electronic connection (assuming the
connection has been enabled when you have connected the cable
between the inserter and the mailing machine).
Congratulations! You have succeeded in metering your first
envelope.
4131934X/B
19/06/2007
GETTING STARTED
by doing the following:
- Log in using the Supervisor Pincode.
- Press the «Batch Config» area to enter rates programming
section.
- Press the
key to be able to modify the presett values.
SETUP
- Define a mail class and an amount for RATE 1, RATE 2...
to RATE 10.
- Validate your setting by pressing
- Logout from the Supervisor.
envelopes by doing the following:
- Press the «Batch Config» area to enter rates programming
section.
- Select «setting A», «setting B» and «setting C» (Settings
B and C are hidden if you have a mechanical connection)
- For each setting, choose a rate class in the list.
- Validate your setting by pressing
START
with mechanical connection, or send «start
STOP
OK
OK
Getting Started
ORIG0060-7
.
.
7
Advertisement
Table of Contents
