ROUTINE MAINTENANCE
2.4.2.
CHECKING AND CLEANING THE TERMINALS
Carefully read
2.4.1.
•
Make sure that the ignition switch is in position " ".
•
Raise the seat.
•
Undo and remove the two screws (1).
•
Remove battery protection.
•
Make sure that the cable terminals (2) and the battery
terminals (3):
-
in good conditions (and not corroded or covered with
deposits);
-
covered with neutral grease or vaseline.
If necessary, proceed as follows:
•
Disconnect the negative cable (-) first and the positive
one (+).
•
Brush the wire with a wire brush, in order to eliminate
any trace of corrosion.
•
Reconnect the positive terminal (+) first and then the
negative one (-).
•
Cover the terminals of the cables and of the battery
with neutral grease or vaseline.
2 - 10
ATLANTIC 125 - 200