ATLANTIC 125 - 200
•
Grasp the bulb connector (2) and pull to disconnect.
•
Twist the bulb holder (3) anticlockwise and extract from
the reflector seat.
•
Extract the bulb.
On refitting:
Insert the bulb into the reflector seat and ensure that
NOTE
the three pegs on the bulb match the slots in the reflector
seat.
•
Position the bulb holder (3) into the reflector seat and
twist clockwise.
•
Connect the bulb connector (2).
TAIL LIGHT BULBS
The tail lights accommodate:
-
Two parking light/brake light bulbs (4).
-
Two rear direction indicator bulbs (5).
NOTE The following procedure applies to both indicators.
To replace:
•
Unscrew the two retaining screws (6) and remove the
lens (7).
WARNING
Proceed carefully.
Do not damage the tabs and/or their recesses.
•
Rotate anticlockwise and
parking/brake light) or (5, direction indicator).
•
Fit a new bulb of equal rating.
NOTE On refitting, ensure the lens (7) locates properly into
its seat.
WARNING
Proceed carefully.
Do not damage the tabs and/or their recesses.
•
Tighten the screws (6) gradually. Do not overtighten or
you will damage the lens (7).
extract
the bulb
(4,
ELECTRICAL SYSTEM
8 - 25