CHASSIS
7.7. HEADSTOCK
7.7.1.
HEADSTOCK REMOVAL
TORQUE WRENCH SETTINGS
Locknut (1)
•
Place the vehicle on a lift with the front wheel
protruding over the lift edge. Put the vehicle on the
centre stand.
•
Place a support underneath the frame.
•
Remove the handlebar,
•
Remove the dashboard,
•
Remove the legshield,
•
Remove the brake calliper from the disc,
•
Release and remove the locknut (1).
•
Release and remove the nut (2).
NOTE Pay attention to the lower bearing balls during front
fork removal.
•
Remove the front fork together with the wheel from the
steering tube.
•
Remove the plastic seal (3).
•
Remove the rotary race (4) and the balls (5) of the
upper bearing.
•
Remove the rotary race (6) and the balls of the lower
bearing (7).
•
Clean off all grease from the bearing components,
including the fixed races (8) and (9).
•
Remove the dust seal (10).
•
Check all components for wear and replace as
required.
NOTE
1.8.1.for the specified bearing grease.
•
Refit all components and adjust play in the bearings.
7 - 64
110 Nm (11.0 kgm)
7.4.1.
7.2.6.
7.1.9.
7.7.2.
ATLANTIC 125 - 200