Priming The Turbochargers On Engines Fitted With Regulateurs Europa Or Hydraulic Governors; Priming The Turbochargers On Engines Fitted With A Woodward Type Eg10 Or 3161 Hydraulic Governor - Perkins 400 Series User Handbook Manual

OPERATING INSTRUCTIONS
For earlier engines not fitted with a stop
lever, disconnect the battery leads and
remove the electric plug from the governor
by unscrewing the locking collar and pulling
the plug out of its socket. (See
3).
Operate the starting control or key switch
and motor the engine over on the starter until
an oil pressure of approximately 40 kPa (5 lb/
in ² ) is indicated on the pressure gauge.
Continue for a further 10 seconds to ensure
that the oil has reached the turbochargers,
and stop the engine by releasing the start
control. Disconnect the battery leads and
reconnect the electric plug in the actuator.
Reconnect the battery leads.
PRIMING THE TURBOCHARGERS ON
ENGINES FITTED WITH REGULATEURS
EUROPA OR HYDRAULIC GOVERNORS
Let the engine run without load for about 5
minutes ensuring the lubricating oil has
reached the turbochargers.
PRIMING THE TURBOCHARGERS ON
ENGINES FITTED WITH A WOODWARD
TYPE UG10 OR
GOVERNOR
WARNING
PRESS THE EMERGENCY STOP
BUTTON IN THE EVENT OF A
PROTECTION EQUIPMENT FAILURE.
NOTE: It is recommended that for initial
starting of new or overhauled engines, that
the load is disengaged, with the governor
speed control lever in the minimum speed
position, the shutdown solenoid in the STOP
position and the air shut-off valves manually
set to the run position (see Fig. 4 and
11).
Check the oil level by means of the sight
gauge. If necessary, add new SAE 30 or
SAE15W/40 engine oil (after lifting the filler
cap) to bring the oil up to the correct level
(see Fig. 2). Ensure that the fuel supply to
the engine is turned off.
24
Fig. 2 & Fig.
3161 HYDRAULIC
THE OPERATOR
MUST BE IN A TO
1
7
6
5
4
Fig. 4
Key
(Fig. 4)
1 Low speed stop
2 Oil filler
3 Compensation adjustment
4 Oil drain plug
5 Compensating needle valve
6 High speed stop
7 Oil level gauge
With the speed control unit set in the idling
position, (for generator duty the governor
minimum and maximum speed stops are
factory set) ensure that the governor speed
lever is in the minimum speed position. Turn
the key in the instrument panel from the stop
position to the start position and motor the
Fig.
engine over on the starter until the oil
pressure gauge registers approximately 40
kPa (5 lb/in ² ). Continue cranking for a further
10 seconds to ensure that the oil has
reached the turbochargers.
4012/16 Diesel, February 1997
2
3