Registering A Dect Handset; Rear Panel Ports - SMC Networks SMCD3USG Install Manual

2.2.3

Registering a DECT Handset

There are two methods to register the DECT handset:

Press DECT Pager button continuously for more than ten seconds, the Gateway will go into
registration mode for you to register a DECT handset with that Gateway.

Press the DECT Register/ WPS button, this LED will blink continuously to indicate the DECT
handset is registering and turn OFF after the registration is done.

2.3 Rear Panel Ports

The rear panel of your SMCD3USG contains a reset button and the ports for attaching the supplied power
adapter and making additional connections.
 
Item Item

Tel

Alarm

Ethernet 1-4

USB

Reset

MoCA/Cable

Power

Connect the a telephone set to the Gateway
Connect the Gateway to the phone line outlet.
Four 10/100/1000 auto-sensing RJ-45 switch ports. Connect devices on
your local area network such as a computer, hub, or switch to these
ports.
This Gateway provides four USB 2.0 high-speed ports. Two of them are
on the rear panel and the other two are located at the Expansion Slot on
the bottom of the Gateway.USB 2.0 high-speed ports for connecting to
USB hard drives and peripherals.
Use this button to reboot the Gateway or restore the default factory
settings (see Chapter 6 "Resetting and Rebooting the Gateway"). This
button is recessed to prevent accidental resets of your Gateway.
Connect your coaxial cable line to this port.
Connect the supplied power adapter to this port.
 
Description
5
 