Installing A 3.5" Hdd/Fdd In The 3.5" Drive Bay And A Slim-Type Cd-Rom/-Rw; Figure 2.4 Installing A Sata Hdd - Advantech ACP-1320BP User Manual

1. Open the front bezel of the drive bay.
2. If you want to install a SATA HDD into SATA tray, it is necessary to remove the
front bezel first. The front bezel is attached to the ACP-1320BP with bezel latch,
but NOT fixed with screws.
3. Left-shift the key latch of one SATA HDD tray to unlock the tray. Hold the handle
of the tray and draw it out from ACP-1320BP chassis.
4. Slide one SATA disk drive into the proper location in the tray and fix it with 4 ~ 6
screws.
5. Return and push the SATA tray to the chassis until the handle of tray is moving
back. Right-shift the key latch of the HDD tray to lock the tray.
6. Repeat Steps 3 to 5 if there is the 2
2.5.2 Installing a 3.5" HDD/FDD in the 3.5" drive bay and a slim-type
CD-ROM/-RW
1. Remove the four screws, which mount the slim-type optical disk drive and 3.5"
HDD brackets on the chassis.
2. Insert the hard drive disk into the proper location in the drive bay and fix it with 4
screws.
3. Connect a suitable cable from the motherboard to an ATA (IDE) HDD or a SATA
cable to a SATA HDD.
4. Find a small PCB converter and connect it to the slim-type optical disk drive.
Then fix it in place by tightening the two screws provided.
5. Insert slim-type optical disk drive into the proper location, and fix it with 4
screws.
6. Insert the proper power connector into each drive.
7. Return the HDD drive and slim-type optical disk drive with the bracket on the
chassis and fix it with four screws.
8. Connect the 40-pin IDE flat cable from the CPU card to the optical disk drive.

Figure 2.4 Installing a SATA HDD

nd SATA HDD to be installed.
9 ACP-1320BP User Manual