Installing The Backplane And The Cpu Card - Advantech ACP-1320BP User Manual

2.3

Installing the backplane and the CPU card

ACP-1320BP accepts 3-slot backplane. To install the backplane, refer to figures and
proceed as follows:
Note! To ensure the best air flow inside the chassis, choosing a CPU cooler
which is lower than 22 mm is highly recommended.
1. Fix the backplane to the backplane holder (T-bar) of chassis with screws.
2. Fix the CPU card on the backplane and card guide with screws.
3. Fix the backplane holder (include CPU card and backplane) on the SATA BP
bracket and card guide on the chassis simultaneously with screws.
4. Plug in the 20/24-pin ATX power connector and +12 V power connector from the
power supply, also the 9-pin USB connectors from the front panel of the chassis.
5. Connect the POWER SW, RESET SW, LAN LED from chassis to the backplane
and HDD LED cables from the alarm board to the backplane.
Figure 2.2 Installing a backplane, CPU card and add-on card
7 ACP-1320BP User Manual