Audio Dubbing - JVC HR-S9600EK Instructions Manual

Audio Dubbing

CD Player etc.
M ixer
output
1 3
2
N O TES:
● When monitoring the sound during Audio Dubbing, the
normal soundtrack is automatically selected. If you wish to
hear the mixed sound (Hi-Fi + Normal soundtracks), press
AU D IO on the remote control to select "
NORM" ( pg. 29).
● Audio dubbing stops automatically when the counter reaches
"0:00:00", and the recorder enters the Play mode. Check the
counter reading before dubbing.
● Audio dubbing is also possible using the rear panel AV1 IN/OUT
or AV2 IN/DECODER connector. When using these connectors,
make sure to select the correct input mode in step 2 .
● Audio dubbing cannot be performed on a cassette that has
had its record safety tab removed.
● When playing back an audio-dubbed tape, press
the remote control to select the soundtrack you wish to hear
( pg. 29).
Downloaded from: https://www.usersmanualguide.com/
CD Player etc.
Audio mixer
O riginal sound
AU D IO O U T
8
+ (L+R) +
AU D IO on
Audio dubbing replaces the normal audio sound of a previously
recorded tape with a new soundtrack.
Normal audio track
Video/Hi-Fi audio
track
MAKE CO N N ECTIO N S
1
Connect an audio component to the AUDIO L + R
connectors on the recorder's front panel.
● When connecting monaural equipment, use only the
recorder's AUDIO L connector.
SET IN PUT MO DE
2
Press N U M BER key "0" and/or TV PRO G so that "F-1" or
"S-1" appears in place of a channel number.
LO CATE ST ART PO IN T
3
Press PLAY to start playback of the tape in your
recorder, and press PAU SE when you find the point
where you want to start dubbing.
EN GAGE AUDIO DUBBIN G
4
Press A. D U B .
● It is possible to take the original sound recorded on
the tape in your recorder and mix it with other
sounds from a microphone, CD player etc. To
perform this audio dubbing with audio mixing,
connect as in the diagram on the left.
● Your recorder enters the Audio Dubbing Pause mode.
(" " blinks, " " and " " light up on the front display
panel.)
● To perform audio dubbing with audio mixing, press
AU D IO M O N ITO R (or AU D IO on the remote
control) to select "
* Audio dubbing with audio mixing is not possible if
you're using a monaural audio component, or if
you don't have an audio mixer.
ST ART DUBBIN G
5
Engage the audio component's Play mode, then press
PLAY to start the tape in your recorder. Audio dubbing
begins at this point.
● " " blinks and " " is displayed on the front display
panel.
● To stop dubbing temporarily, press
PLAY to resume dubbing.
EN D AUDIO DUBBIN G
6
Press STO P to stop the tape in your recorder, and
engage the audio component's Stop mode.
41
Pre-recorded tape
Audio-dubbed tape
+ (L+R)" at this point.
PAU SE . Press