Replacing The Aoc-Simso (Bmc) Daughter Card; Figure 3-12 Bmc Daughter Card Removal - Silicon Graphics Virtu VN200 Hardware User's Manual

Replacing the AOC-SIMSO (BMC) Daughter Card

A
007-5483-001
The AOC-SIMSO daughter card (BMC) resides in a slot attached to the node board. The
rear panel BMC LAN port is connected to the BMC using a short USB cable.
1. Remove the graphics card in accordance with the instructions on
2. Press the retaining bracket arms apart and gently lift the end of the daughter card
that is not in the bracket (refer to
3. Disconnect the daughter card from the node board connector and remove the
daughter card (refer to
Bracket
Figure 3-12 BMC Daughter Card Removal
Figure 3-12, A).
Figure 3-12, B).
B
Hardware Replacement Procedures
page 69.
AOC-SIMSO
card (BMC)
71