Yamaha TZ125M1 Owner's Service Manual page 84

STEERING DAMPER ADJUSTMENT
3-34
• Tighten the ring nut 3 using ring nut
wrench 4.
NOTE:
Set the torque wrench to the ring nut wrench
so that they form a right angle.
ª
Ring nut wrench:
YU-33975/90890-01403
Ring nut (initial tightening):
46 Nm (4.6 m•kg, 33 ft•lb)
• Loosen the ring nut one turn.
• Retighten the ring nut using the ring nut
wrench.
U
W
Avoid over-tightening.
Ring nut (final tightening):
1 Nm (0.1 m•kg, 0.7 ft•lb)
• Check the steering shaft by turning it lock
to lock. If there is any binding, remove the
steering shaft assembly and inspect the
steering bearings.
• Install the handle crown 5 and reservoir
tank 6.
Steering shaft nut 7 7 :
º
80 Nm (8.0 m•kg, 58 ft•lb)
Pinch bolt (front fork) 8 8 :
15 Nm (1.5 m•kg, 11 ft•lb)
Bolt (reservoir tank) 9 9 :
5 Nm (0.5 m•kg, 3.6 ft•lb)
• Install the cowling.
6. Install:
• Steering damper
EC36V002
STEERING DAMPER ADJUSTMENT
1. Adjust:
• Damping force
By turning the adjuster 1.
Stiffer a a ≥
≥ Increase the compression
damping force. (Turn the
adjuster 1 1 in.)
Softer b b ≥
≥ Decrease the compression
damping force. (Turn the
adjuster 1 1 out.)
INSP
ADJ