Yamaha TZ125M1 Owner's Service Manual page 65

FRONT BRAKE PAD INSPECTION AND REPLACEMENT
2. Adjust:
• Brake pedal height
Pedal height adjustment steps:
• Loosen the locknut 1.
• Turn the adjusting nut 2 until the pedal
height is within specified height.
• Tighten the locknut.
EC365050
FRONT BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
• Brake pad thickness a
Out of specification ≥ Replace as a set.
{
Brake pad thickness a a :
Standard
5.3 mm (0.21 in)
2. Replace:
• Brake pad
Brake pad replacement steps:
• Loosen the pad pin 1 and remove the
caliper 2.
• Remove the cotter pin 3, pad pin 4, pad
support 5 and brake pads 6.
• Connect the transparent hose 7 to the
bleed screw 8 and place the suitable con-
tainer under its end.
• Loosen the bleed screw and push the
caliper piston in.
C C CAUTION:
U
Do not reuse the drained brake fluid.
• Tighten the bleed screw.
Bleed screw:
6 Nm (0.6 m•kg, 4.3 ft•lb)
3-15
INSP
ADJ
<Limit>
1.0 mm (0.04 in)