Yamaha TZ125M1 Owner's Service Manual page 196

FRONT FORK
19.Install:
• Fork spring 1
• Spacer guide 2
• Spacer 3
NOTE:
Install the fork spring with its smaller dia. por-
tion upward.
20.Attach:
• Rod puller 1
• Rod puller attachment 2
• Fork spring compressor 3
• Rod holder 4
NOTE:
• Pull up the damper rod with the rod puller and
rod puller attachment.
• While pressing down the spacer 5 with the
fork spring compressor, set the rod holder
between the locknut 6 and spacer.
Rod puller 1 1 :
YM-01437/90890-01437
Rod puller attachment 2 2 :
g
90890-01436
Fork spring compressor 3 3 :
YM-01441/90890-01441
Rod holder 4 4 :
YM-01434/90890-01434
21.Adjust:
• Distance a
Out of specification ≥ Turn the locknut 2
until the specified distance is obtained.
c
Distance a a :
13 mm (0.51 in)
Between damper rod 1 1 top and
locknut 2 2 top.
22.Adjust:
• Rebound damping adjuster position a
Out of specification ≥ Turn the adjuster 1
b
until the specified position is obtained.
Rebound damping adjuster posi-
tion a a :
Zero mm (Zero in)
5-35
CHAS