Yamaha TZ125M1 Owner's Service Manual page 122

CLUTCH
9. Install:
• Pressure plate 1
NOTE:
Align the punch mark a on the pressure plate
with the punch mark b on the clutch boss.
10.Install:
• Clutch spring 1
• Screw (clutch spring) 2
NOTE:
Tighten the screws in stages, using a criss-
cross pattern.
11. Check:
• Push lever position
Push the push lever 1 forward until it
stops. With the push lever in this position,
the projection a of the push lever should
be aligned with the mating mark b on the
crankcase.
Not aligned ≥ Adjust.
12.Adjust:
• Push lever position
Push lever position adjustment steps:
T
• Loosen the locknut 1.
• Turn the adjuster 2 to align the projection
of the push lever with the mating mark on
the crankcase.
• Tighten the locknut.
Locknut:
6 Nm (0.6 m•kg, 4.3 ft•lb)
4-34
ENG
6 Nm (0.6 mdkg, 4.3 ftdlb)
T