Yamaha TZ125M1 Owner's Service Manual page 80

REAR SHOCK ABSORBER REBOUND DAMPING
FORCE ADJUSTMENT
]
Spring length (installed) a a :
Standard length
138 mm (5.43 in)
NOTE:
The length of the spring (installed) changes 1.5
mm (0.06 in) per turn of the adjuster.
C C CAUTION:
Never attempt to turn the adjuster beyond
the maximum or minimum setting.
4. Tighten:
• Locknut
EC36N030
REAR SHOCK ABSORBER REBOUND
DAMPING FORCE ADJUSTMENT
1. Adjust:
• Rebound damping force
By turning the adjuster 1.
Stiffer a a ≥
≥ Increase the rebound damp-
ing force. (Turn the adjuster
1 1 in.)
Softer b b ≥
≥ Decrease the rebound damp-
ing force. (Turn the adjuster
1 1 out.)
]
Extent of adjustment:
Maximum
Fully turned-in
position
• STANDARD POSITION:
This is the position which is back by the spe-
cific number of clicks from the fully turned-in
position. (Which align the punch mark a on
a
the adjuster with the punch mark b on the
bracket.)
Standard position:
About 18 clicks out
3-30
INSP
ADJ
Extent of adjustment
130~150 mm
(5.12~5.91 in)
40 Nm (4.0 mdkg, 29 ftdlb)
T
Minimum
Fully turned-out
position