Yamaha TZ125M1 Owner's Service Manual page 101

CARBURETOR AND REED VALVE
2. Install:
CAUTION:
C C
• Before installing the solenoid valve, blow
• Apply the engine oil on the solenoid valve
3. Install:
4. Install:
5. Install:
4-13
• O-ring 1
• Solenoid valve 2
• Clamp 3
• Screw (clamp) 4
To carburetor 5.
air on the solenoid valve and its installing
location on the carburetor in order to
remove any foreign particles such as
chips etc.
thread.
• Pilot air screw 1
µ
Note the following installation points:
• Turn in the pilot air screw until it is lightly
seated.
• Turn out the pilot air screw by the number
of turns recorded before removing.
Pilot air screw:
Factory-set number of turns
out
• Starter plunger 1
• Pilot jet 1
• Main jet 2
ENG