Yamaha TZ125M1 Owner's Service Manual page 74

FRONT FORK TOP END ADJUSTMENT
• Adjust the front fork top end a.
≠
Front fork top end a a :
Standard
18 mm (0.71 in)
C C CAUTION:
Never attempt to install the front fork
beyond the maximum or minimum set-
ting.
W
Always adjust each front fork to the
same setting. Uneven adjustment can
cause poor handling and loss of stabili-
ty.
• Tighten the pinch bolts (handle crown and
under bracket).
¶
Pinch bolt (handle crown):
15 Nm (1.5 m•kg, 11 ft•lb)
Pinch bolt (under bracket):
20 Nm (2.0 m•kg, 14 ft•lb)
C C CAUTION:
Tighten the under bracket to specified
torque. If torqued too much, it may cause
the front fork to malfunction.
• Adjust the handlebar position b and steer-
ing damper stay position c.
§
Handlebar position b b :
20 mm (0.79 in)
Steering damper stay position c c :
Zero mm (Zero in)
• Tighten the pinch bolts (handle bracket
and steering damper stay).
¶
Pinch bolt (handle bracket):
8 Nm (0.8 m•kg, 5.8 ft•lb)
Pinch bolt (steering damper stay):
7 Nm (0.7 m•kg, 5.1 ft•lb)
3-24
INSP
ADJ
Extent of adjustment
Zero~20 mm
(Zero~0.79 in)