Enterasys X-Pedition XSR-1805 Getting Started Manual page 44

Optional: Configuring Remote Auto Install
to IP addresses 133.133.1.2 and 133.133.1.3. If the DLCI will connect to a remote XSR running RAI,
then add the bootp parameter after the static IP address.
This configuration supports two remote XSRs connected on DLCIs 16 and 18. Make sure with your
Frame Relay provider that these DLCIs terminate at the location of the remote XSRs. To add more
remote XSRs, you will need additional DLCIs.
Note the use of a helper-address to specify a destination address for UDP broadcasts and forward
traffic to the DNS and TFTP servers. In the example below, DNS and TFTP servers reside on the
same node - 10.10.1.2 (configuration of DNS and TFTP servers are not shown here). In short, the
DNS server should map IP addresses 133.133.1.2 and 133.133.1.3 to hostnames. On the TFTP
server, you should create a startup-config file with names <hostname>-config in a directory
accessible by TFTP.
XSR(config)#interface serial 1/0.1 multi-point
XSR(config-if<S1/0.1>)#ip helper-address 10.10.1.2
XSR(config-if<S1/0.1>)#ip address 133.133.1.1
XSR(config-if<S1/0.1>)#frame-relay interface-dlci 16 ip 133.133.1.2 bootp
XSR(config-if<S1/0.1>)#frame-relay interface-dlci 18 ip 133.133.1.3 bootp
XSR(config-if<S1/0.1>)#no shutdown
XSR(config-if<S1/0.1>)#exit
XSR(config)exit
XSR#copy running-config startup-config
RAI displays the following phased output on the remote node. Refer to the accompanying notes
for additional explanation of phases.
********************* REMOTE AUTO INSTALL STARTING ***************
+
RAI is starting up.
************* REMOTE AUTO INSTALL ATTEMPTING FOREVER **************
+
Persistent (or Non-Persistent) RAI is attempted.
Phase 0 - Initialization and Starting search for proper media-type
Phase 0 - Trying media-type V35
******** PRESS ANY KEY TO TERMINATE REMOTE AUTO INSTALL ***********
+
A periodic reminder that you can terminate the program at any time by depressing any key on your keyboard. Be aware
that any existing startup-config that may exist in the node will be executed.
Phase 1 - Trying media-type RS232
+
Upon failing, the next media-type is tried.
Phase 1 - Frame Relay interface Serial 1/0 reported DLCI 16 active
+
Frame Relay has successfully found a FR network with active DLCIs.
Phase 2 - transmitting bootp - attempt #1
+
The bootp client is sending out a request. At most, five requests will be tried.
Phase 3 - received IP address: 133.133.1.2
+
The bootp client has received a response and the IP address for this interface is 133.133.1.2.
Phase 4 - Sending out Reverse DNS query onto Frame Relay
+
rDNS is sending out a query looking for the hostname for IP address 133.133.1.2
3-4 Software Configuration