Regulatory Compliance Information - Enterasys X-Pedition XSR-1805 Getting Started Manual

Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes Personal
vorgenommen werden.
Enterasys Networks reserves the right to make changes in specifications and other information contained in this document and
its web site without prior notice. The reader should in all cases consult Enterasys Networks to determine whether any such
changes have been made.
The hardware, firmware, or software described in this document is subject to change without notice.
IN NO EVENT SHALL ENTERASYS NETWORKS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR
CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF
OR RELATED TO THIS DOCUMENT, WEB SITE, OR THE INFORMATION CONTAINED IN THEM, EVEN IF
ENTERASYS NETWORKS HAS BEEN ADVISED OF, KNEW OF, OR SHOULD HAVE KNOWN OF, THE POSSIBILITY OF
SUCH DAMAGES.
Enterasys Networks, Inc.
50 Minuteman Road
Andover, MA 01810
© 2005 Enterasys Networks, Inc. All rights reserved.
Part Number: 9033724‐09 July 2005
ENTERASYS, ENTERASYS NETWORKS, ENTERASYS XSR, and any logos associated therewith, are trademarks or registered
trademarks of Enterasys Networks, Inc. in the United States and other countries. All other product names mentioned in this
manual may be trademarks or registered trademarks of their respective owners.
Documentation URL: http://www.enterasys.com/support/manuals
Documentacion URL: http://www.enterasys.com/support/manuals
Dokumentation http://www.enterasys.com/support/manuals
The XSR complies with Title 47, Part 15, Class A of FCC rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired operation.
NOTE: The XSR has been tested and found to comply with the limits for a class A digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference when the XSR is operated in a
commercial environment. This XSR uses, generates, and can radiate radio frequency energy and if not installed in accordance
with the operator's manual, may cause harmful interference to radio communications. Operation of the XSR in a residential
area is likely to cause interference in which case you will be required to correct the interference at your own expense.
WARNING: Modifications or changes made to the XSR, and not approved by Enterasys Networks may void the authority
granted by the FCC or other such agency to operate the XSR.
The XSR complies with Part 68 of the FCC rules and the requirements adopted by the Administrative Council for Terminal
Attachments (ACTA). A label on the circuit board of the Network Interface Module contains, among other information, a
product identifier in the format listed in the following table. If requested, this number must be provided to the telephone
company.
ii

Regulatory Compliance Information

Federal Communications Commission (FCC) Notice
Notice