Setting Up Snmp Community Strings, Traps And V3 Values - Enterasys X-Pedition XSR-1805 Getting Started Manual

10. To set up the Console port as a serial port, perform the following:
• Enter interface serial 0 to decouple the port from the CLI and acquire Interface mode.
• Enter no shutdown to keep the interface enabled.
• Enter any other commands listed in this section.
11. Enter dialer pool-member <number> to configure dialer interface.
12. Enter physical-layer <sync | async> to set the interface type.
13. Enter no shutdown to keep the interface enabled.
14. Enter show ppp interface serial <slot/card/port> to display PPP status on the interface.
Remember to save your configuration after all edits.

Setting Up SNMP Community Strings, Traps and V3 Values

1. Enter snmp-server community <string> <ro | rw> <ACL #> to create an SNMP community
with an optional ACL. SNMP is disabled by default, but entering any SNMP configuration
command except snmp-server disable will enable the SNMP server.
You can choose either Read Only or Read/Write privileges and can create up to 20 read-only
or read-write community strings with standard memory installed. Also, community-based
write access is available for the ct-download MIB only. For write access to other MIBs, use
SNMPv3. Also, a RW community is unnecessary for SNMPv3.
2. Enter snmp-server host <IP address> traps <community-string [snmp]> to specify where traps
are sent.
3. Enter snmp-server location <location-string> to specify where the SNMP device is sited.
4. Enter snmp-server enable [traps [snmp [authentication]]] to define which traps are sent.
5. Optional. For SNMPv3, enter
<name> write <name> to add a group.
Groups offer users authorization choices and read/write privileges.
6. Optional. For SNMPv3, enter
excluded} to specify a view.
Views offer users selective access to the family tree or Object IDs.
7. Optional. For SNMPv3, enter
[encrypted][auth {md5 | sha}
Users can have different levels of encryption and passwords.
Note: Only standard ACLs can be applied to SNMP configuration commands.
Note: Because only one operator can set the XSR at any time, you must exit Global mode to
perform SNMPv3 configuration. Otherwise, the SNMP set request will fail with the "resource
unavailable" message. This rule applies to configuration values, not image downloads.
Setting Up SNMP Community Strings, Traps and V3 Values
snmp-server group <name> v3 {
<name> {oid-tree | treeEntryName}{included |
snmp-server view
<username> <group name>
snmp-server user
[priv des56 priv-password]]} to add a user.
auth-password
auth | nonauth | priv}
read
v3
XSR Getting Started Guide 3-17