Configuring The Xsr Name And User Information; Setting User Name, Privilege And Password - Enterasys X-Pedition XSR-1805 Getting Started Manual

Phase 2 - ADSL - searching for pvc's...vpi/vci (0/0)
+
The XSR looks for PVC 0/0 and higher.
Phase 2 - ADSL - searching for pvc's...vpi/vci (0/38)
+
The XSR looks for PVC 0/38 and higher.
Phase 3 - ADSL - trying to connect on 0/35 with snap PPPoE
+
PVC 0/35 is found, SNAP PPPoE encapsulation is applied and authentication tried if required.
Phase 3 - ADSL - waiting for IP to connect (54 sec)
+
The XSR waits one minute for the PPPoE connection to come up.
Phase 4 - ADSL - IP is connected on 0/35, prepare to load startup config
+
The XSR starts downloading the startup-file.
Phase 6 - ATM/ADSL - retrieving file 0000019876543210-confg from tftp server 25
5.255.255.255
+
The startup-config name is the serial number of the XSR.
Phase 7 - preparing node to execute startup-config

Configuring the XSR Name and User Information

1. At the CLI prompt, enter enable to acquire Privileged EXEC mode.
2. Enter configure to acquire Global mode.
3. Enter hostname <your XSR designation>.
4. Enter username <name> <privilege level> password <cleartext | secret> <0 | 5> <password>.
5. Enter banner login <your welcome text> to add a user login banner.
Remember to save your configuration after all edits.

Setting User Name, Privilege and Password

The value <name> is the user's designation - for sake of clarity, often set as the name of the facility
or site the XSR connects to. The value <privilege level> (0-15) prioritizes this user in terms of
configuration rights with 15 as the highest and 0 the lowest (default). When you create a new user
you can decide which privilege that user will have (if you are admin). For example, a user with
privilege 7 will be allowed to execute only commands with privilege levels between 0 and 7.
Default privilege levels are defined for all commands and the admin user and are listed in the XSR
CLI Reference Guide under the
privilege by entering:
command_group>
The value <cleartext | secret> can be sent in the clear or encrypted with a 0 (the input password is
not expected to be unencrypted so the XSR will encrypt it) or 5 (the input password is expected to
already be encrypted so it will not be encrypted again). The value <pass> is the password
associated with the specified name. The MD5 algorithm is encrypts the password.
privilege
privilege <configuration_mode> level <0-15> <command |
.
Note: Newly created users are stored in the startup config file. You can also delete admin but only if
you first create another level 15 user.
Configuring the XSR Name and User Information
command. You can change a command's default
XSR Getting Started Guide 3-7