Bri Leased Frame Relay; Bri Switched Line - Enterasys X-Pedition XSR-1805 Getting Started Manual

Configuring the WAN Ports
3. Enter
4. Enter
5. Enter

BRI Leased Frame Relay

1. Enter
port and channel 1 or 2.
2. Enter
3. Enter
4. Enter
Management Interface type.
5. Enter interface
select the BRI port, channel, and sub-interface.
6. Enter
7. Enter
mode and assign a data-link connection identifier to the Frame Relay sub-interface.
8. Enter

BRI Switched Line

1. Enter
2. Enter
basic-ntt>
3. Enter
telephone numbers.
4. Enter
5. Enter
6. Enter
priority to this BRI interface. You can add additional dial pools as needed.
7. Enter
8. Enter
9. Enter
10. Enter
11. Enter
number and associated Map Class.
12. Enter any additional dialer strings as instructed above.
13. Enter
physical interface.
14. Enter
15. Enter
3-10 Software Configuration
ip address <xxx.xxx.xxx.xxx>/24
to select PPP encoding.
encapsulation ppp
to keep the BRI interface enabled.
no shutdown
interface bri 0:<1 | 2>.<1-30>
encapsulation frame-relay
to keep the BRI interface enabled.
no shutdown
frame-relay lmi-type <ilmi | ansi | q933a | auto | none>
bri 0:<1 | 2>.<1-30> multi-point
ip address <xxx.xxx.xxx.xxx>/24
frame-relay interface-dlci <16-1007>
to keep the BRI sub-interface enabled.
no shutdown
to acquire Interface mode and select the BRI port.
interface bri 0
isdn switch-type <basic-5ess | basic-dms100 | basic-net3 | basic-ni1 |
to select the Central Office switch type for the ISDN port.
isdn spid1 <SPID><LDR>
isdn spid2 <SPID><LDR>
to keep the BRI interface enabled.
no shutdown
dialer pool-member <1-255> priority <0-255>
to quit BRI Interface mode.
exit
interface dialer <0-255>
ip address <xxx.xxx.xxx.xxx/24
to select PPP encoding.
encapsulation ppp
dialer string <phone number> class <Map Class name>
dialer pool <1-255>
to verify your ISDN and dialer configuration.
show interface
to keep the Dialer interface enabled.
no shutdown
to set an IP address for the BRI interface.
to acquire BRI Interface mode and select the BRI
to select Frame Relay encoding.
to set an IP address for the BRI interface.
to acquire Frame Relay DLCI Interface
for the SPID (ISDN service) and LDR (local directory)
for a second SPID as needed.
to acquire Interface mode and select the Dialer port.
to set an IP address for the Dialer port.
to create a dial pool from which the dialer interface will select a
to select the Local
to acquire BRI Sub-interface mode and
to add a dialer pool and associated
to specify the destination