Error Messages - Toshiba e-studio16 Operator's Manual

Error messages

Please read the instructions in the chapter "NETPANEL FUNCTION", then try the
following actions with the appropriate error message.
Error Message Displayed
Fatal Error on Controller Memory
Fatal Error on Controller NVRAM
Fatal Error on Memory
Fatal Error on Fan Motor
Fatal Error on Fuser
Fatal Error on Laser Scan Unit
Fatal Error on Main Motor
Fatal Error on NIC
Fatal Error on Flash ROM Checksum
Fatal Error on Engine I/F
Fatal Error on Finisher
Fatal Error on Controller Option Memory
Fatal Error
Paper Empty in SFB
Paper Empty in Cassette1
Paper Empty in Cassette2
Paper Empty in Cassette3
Paper Empty in Cassette4
Paper Empty in LCF
Paper Jam in Bridge Cover
Paer Jam in Duplex Unit
Paper Jam in Ejection
Paper Jam in Engine Inside
Paper Jam in Insertion
Process Unit Not Available
NIC Card Not Available
NIC Card Not Ready
Bridge Cover Open
Duplex Unit Cover Open
Front Cover Open
Job Separator Cover Open
Side Cover Open
Offset Cover Open
Finisher Joint Open
Standard Output Tray Paper Full
Finisher1 Paper Full
Finisher2 Paper Full
Action
Turn off the power and call for service.
Turn off the power and call for service.
Turn off the power and call for service.
Turn off the power and call for service.
Turn off the power and call for service.
Turn off the power and call for service.
Turn off the power and call for service.
Turn off the power and call for service.
Turn off the power and call for service.
Turn off the power and call for service.
Turn off the power and call for service.
Turn off the power and call for service.
Turn off the power and call for service.
Load paper in SFB (Stack Feed Bypass).
Load the paper in Cassette 1.
Load the paper in Cassette 2.
Load the paper in Cassette 3.
Load the paper in Cassette 4.
Load the paper in LCF.
Open the Bridge Cover and clear the paper jam.
Open the Duplex Unit Cover and clear the paper
jam.
Clear the paper jam in the paper exit.
Open the Front Cover and clear the paper jam.
Clear the paper jam in the paper feeding entrance.
Please check process unit.
Close the Bridge Cover.
Close the Duplex Unit Cover.
Close the Front Cover.
Close the Job Separator Cover.
Close the Side Cover.
Close the Offset Cover.
Join Finisher to Copier.
Remove the paper from the Standard Output Tray.
Remove the paper from the Finisher1.
Remove the paper from the Finisher2.
-
-
229