Pvh58 Wiring Harness Connections - Marquis Infinite MQRB4436N Installation Instructions Manual

PVH58
WARNING
A qualified electrician must connect
electrical wiring to junction outlet for
built-in installation.
Follow all codes.
Caution
: Electrical installation to be done by a qualified installer. All wires must be connected and grounded in accordance with
CSA Standard C22.1- Canadian Electrical Code part 1 or with the National Electrical Code, ANSI /NFPA 70 (latest edition) and /or in
accordance with local codes.
PVH58 EXTENSION HARNESS
The PVH58 comes supplied with a 20 foot wiring harness. If required, more
harnesses can be ordered. These harnesses are male to female, and can be
connected together.
Strain Relief: If extension harnesses are used, connect them using a junction box,
as shown.
This will provide strain relief and ensure that the connection does not come apart.
CONNECTION OF WIRING HARNESS AT FIREPLACE
Insert Wiring Harness through specified ¾" opening in unit. Push on connector until it snaps into place.
FOLLOW EITHER MILLIVOLT OR IPI SYSTEM INSTRUCTIONS TO COMPLETE
Wiring Harness Connections
WARNING
Electrical Grounding Instructions –
This appliance is equipped with a
three – pronged (grounding) plug for
your protection against shock hazard
and should be plugged directly into a
properly grounded three-prong
receptacle.
Wiring Harness enters
fireplace here
(see photos below).
THE INSTALLATION.
WARNING
Label all wires prior to disconnection
when servicing controls. Wiring errors
can cause improper and dangerous
operation. Verify proper operation and
servicing.
Extension Harness Connection
95