Table of Contents
Advertisement
LK2 Halogen Lamp Kit MQRB4436 / MQRB5143
Please follow the current ANSI/NFPA 70 National Electrical Code in the USA and CAN/CSA C22.1 Canadian National
SYSTEM NOTES
1.
Each lamp is running on a dedicated circuit (Parallel circuit). This means that if one bulb fails the other will remain
operational.
2.
Switch circuit is on low voltage side of transformer.
3.
Solid-state transformer is designed to run halogen lamps ONLY.
4.
To remove leads from the 6 port terminal, simply insert a pin to release the grip on the wire.
Note: Lightbulbs NOT covered under Warranty.
This appliance is equipped with a three-prong (grounding) plug for your protection against shock
hazard and should be plugged directly into a properly grounded three-prong receptacle. Do not cut
or remove the grounding prong from this plug.
Electrical Code in Canada.
WARNING
Electrical Grounding Instructions
76
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
