Network Mailbox Message; Using Several Handsets; Registering Handsets - Siemens Gigaset S675IP User Manual

Network mailbox message

The way in which you are informed of new
messages in the network mailbox depends
on the relevant fixed line network or VoIP
provider.
See user guide for each network mailbox.

Using several handsets

Registering handsets

You can register up to six handsets to your
base station.
You can register your Gigaset S67H hand-
set on up to four base stations.
Please note:
– If a number of handsets are registered on
your base station, you can simultaneously
make two calls via the Internet and one via
the fixed line network. Up to two additional
internal connections are also possible.
– Selecting the connection via the talk key
(page 24) is not supported on GAP hand-
sets. Therefore, if you enter a number with-
out a line suffix and without defining a dial-
ling plan for the phone number, it will be
dialled via Default Line
enter a "*" (star) at the end of the phone
number, it will be dialled via the non-
default connection.
– After registration, all the phone numbers
for the phone will be assigned to the hand-
set as receive numbers. It will use the fixed
line network number and the first VoIP
number as send numbers. For how to
change the assignments, see page 105.
(page 85). If you
Registering another Gigaset S67H
handset on the Gigaset S675 IP
Before you can use your handset, you
must register it to a base station.
You must initiate handset registration on
the handset and on the base station.
If the handset has been registered suc-
cessfully, the handset returns to idle sta-
tus. The handset's internal number is
shown in the display e.g.
repeat the procedure. Registration can
take up to one minute.
On the handset
¢ ¢
v Ð
Handset
s
Select base station, e.g.
and press
~
Enter the system PIN of the
base station (the default is
0000) and press
shows e.g.
On the base station
¤
Within 60 sec. press and hold the regis-
tration/paging key on the base station
(page 2) (approx. 3 sec.).
The handset is given the lowest available
internal number (1–6). If a number of
handsets are registered on the base sta-
tion, the internal number appears in the
display after registration, e.g.
means that the internal number 2 was
assigned to the handset.
Please note:
If six handsets are already registered to the
base station, there are two options:
– The handset with the internal number 6 is
in idle status: the handset you wish to reg-
ister is assigned the number 6. The handset
that was previously number 6 is de-regis-
tered.
– The handset with the internal number 6 is
being used: the handset you wish to regis-
ter cannot be registered.
Using several handsets
1. If not,
Int
¢
Register H/Set
Base 1
.
§OK§
. Display
§OK§
and flashes.
Base 1
INT 2. This
71