Appendix; Care; Contact With Liquid; Questions And Answers - Siemens Gigaset S675IP User Manual

Appendix

Appendix

Care

¤
Wipe down the base station and hand-
set with a damp cloth (no solvents) or
an antistatic cloth.
Never use a dry cloth. This can cause
static.

Contact with liquid

If the handset should come into contact
with liquid:
¤
Switch the handset off and remove
the batteries immediately.
¤
Allow the liquid to drain from the hand-
set.
¤
Pat all parts dry, then with the battery
compartment open and the keypad fac-
ing down place the handset in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
¤
Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.

Questions and answers

If you have any questions about using
your phone, visit us at
www.siemens.com/gigasetcustomercare
at any time. The table below contains a list
of common problems and possible solu-
tions.
118
!
Please note:
To support the service team, it can be helpful if
you have the following information to hand:
– Version of firmware, EEPROM and your
phone's MAC address
You can check this information with the
Web configurator (page 117). For how to
display the MAC address on your handset,
turn to page 89.
– VoIP status code (page 121)
For problems with VoIP connections, you
should set VoIP status messages to be dis-
played on your handset (page 87,
page 116). These messages contain a sta-
tus code that helps when the problem is
analysed.
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key
2. The battery is flat.
¥
Charge the battery or replace it
(page 10).
The keys of a handset do not respond when
pressed.
The keypad lock is activated.
¥
Press and hold the hash key
(page 28).
"Base X" flashes on the display.
1. The handset is outside the range of the
base station.
¥
Move the handset closer to the base
station.
2. The handset has been de-registered.
¥
Register the handset (page 71).
3. The base station is not turned on.
¥
Check the base station's mains adapter
(page 13).
4. The base station firmware is currently being
updated (page 85/page 114).
¥
Please wait until the update is complete.
"Base Search" flashes in the display.
The handset is set to
Best Base
tion is turned on or within range.
¥
Move the handset closer to the base sta-
tion.
¥
Check the base station mains adapter.
a
.
#
and no base sta-