Table of Contents
Advertisement
Installation
Electrical Line Connection
Remove the cover
a
from the fireplace
junction box.
Optional Electrical Line Location
Remove the cover plate on the bottom of the
a
fireplace (save these nuts).
Position the cover plate over the
c
electrical inlet hole on the right side
of the fireplace and secure using the
nuts removed in step "a".
Travis Industries
(for qualified installers only)
Insert the sheathed cable from the power source through
b
this cable clamp. Once the wires are attached, tighten
the clamp to secure the cable.
Electrical
Connector
Attach the common (white), ground (exposed or green)
c
wires, and hot (black) wires from the power source to the
electrical connector (attached to the fireplace).
7/16" Wrench
7/16" Wrench
4030612
Standard
Screwdriver
WARNING: Make sure power is
off from the power lead before
conducting any wiring.
Remove the two screws securing the
b
electrical inlet (save these screws).
Position the electrical inlet assembly over the
d
hole in the baseplate of the fireplace and
secure using the screws removed in step "b".
1/4" Nutdriver
1 3
Replace the
d
cover removed
in step "a".
1/4" Nutdriver
1 0 0 - 0 1 1 4 3
Advertisement
Table of Contents
