Konica Minolta bizhub C451 Network Scanner Operations page 132

4
8
Touch [OK].
9
Touch [Host Address], and then type in the IP address or host name.
– To enter a host name, touch [Host Name Input], and then type in the host name, using the keyboard
that appears.
– To enter an IP address, touch [IPv4 Address Input] or [IPv6 Address Input], and then type in the
address, using the keypad or the number buttons that appear. Touch
to the desired position, and then type in the numbers.
– When the input format is switched to entering an IP address after the host name was entered, the
host name is cleared.
– If [Host Name Input] is touched after the IP address was entered, the entered IP address is saved
and the input screen appears.
– When [Host Name Input] is touched, check that the DNS setting is correctly specified. For details
on the DNS settings, refer to "TCP/IP settings" on page 5-13.
10
Touch [OK].
11
Touch [File Path], and then type in the file path, using the keyboard that appears.
12
Touch [OK].
13
Touch
New screen 2/2 appears.
14
Touch [User ID], and then type in the user ID, using the keyboard that appears.
– To cancel registration of the user ID, touch [ON] beside "anonymous".
15
Touch [OK].
16
Touch [Password], and then type in the password, using the keyboard that appears.
17
Touch [OK].
18
If necessary, specify settings for "anonymous", "PASV mode", "Proxy" and "Port Number".
– To enter a port number, press the [C] (clear) key to clear the current value, and then use the keypad
to type in the port number.
– If a value outside the allowable range is specified, the message "Input error" appears. Type a value
within the allowable range.
19
Touch [OK].
The FTP destination is registered.
4-16
or .
Specifying utility mode parameters
or to move the cursor
bizhub C451/C550/C650