Table of Contents
Advertisement
Understanding the printer menus
Custom Scan Sizes menu
Use
Custom Scan Size [x]
Scan Size Name
Width
Height
Orientation
2 scans per side
Off
On
Universal Setup menu
Menu item
Units of Measure
Inches
Millimeters
Portrait Width
3–14.17 inches
76–360 mm
Portrait Height
3–14.17 inches
76–360 mm
Feed Direction
Short Edge
Long Edge
To
Specify a custom scan size name, size, and page orientation.
Notes:
•
8.5 inches is the U.S. factory default setting for Width. 216 mm is the
international factory default setting for Width.
•
14 inches is the U.S. factory default setting for Height. 356 mm is the
international factory default setting for Height.
•
Portrait is the factory default setting for Orientation.
•
Off is the factory default setting for 2 scans per side.
Description
Identifies the unit of measure
Note: Inches is the US factory default setting. Millimeters is the
international factory default setting.
Sets the portrait width
Notes:
•
8.5 inches is the US factory default setting. Inches can be increased
in 0.01‑inch increments.
•
216 mm is the international factory default setting. Millimeters can
be increased in 1‑mm increments.
•
If the width exceeds the maximum, then the printer uses the
maximum width allowed.
Sets the portrait height
Notes:
•
14 inches is the US factory default setting. Inches can be increased in
0.01‑inch increments.
•
356 mm is the international factory default setting. Millimeters can
be increased in 1‑mm increments.
•
If the height exceeds the maximum, then the printer uses the
maximum height allowed.
Specifies the feed direction
Notes:
•
Short Edge is the factory default setting.
•
Long Edge appears only if the longest edge is shorter than the
maximum width supported by the tray.
129
Advertisement
Table of Contents
