Kingsman Marquis Infinite MQRB4436 Installation Instructions Manual page 69

NOTE: The Remote Receiver module can also be located outside
of the appliance to a maximum of 6ft away installed in a certified
deep wall switch electrical box (2-3/4" depth). For this
configuration an extension wiring harness (P/N: 1001-P904SI) is
required.
Electrical Supply in Series: The entire IPI system can be powered by a
single power source (i.e. by the AC Adapter). This is advantageous if you
do not want to supply extra batteries. To achieve this simply connect the
AC Adapter into the Remote Control wiring harness instead of the main
IPI harness. From the Remote wiring harness, use its male plug-in
connector and connect it to the female plug-in in the main IPI harness.
Now the circuit is complete. So the way it works is that electrical power is
supplied to the Remote Receiver module and then proceeds to the Main
IPI module. Furthermore, note that a Backup Battery Pack is not required
in this configuration. Instead, batteries in the Remote Receiver act as the
backup supply.
Consult your Fireplace Installation Manual for IPI instructions for your specific unit.
Standing Pilot Mode for Colder Climates
For IPI models it may be necessary to set the appliance to Standing Pilot mode to maintain
heat in the cavity. The purpose of this procedure is to prevent cold air from penetrating the
chimney and then onto the living space. Therefore, when the internal temperature is slightly
elevated the fireplace is able to freely exhaust its combustion and hence making it easier to
startup.
69