Table of Contents
Advertisement
CAUTION
To avoid equipment damage, always
align directional handle to DOWN position
before lowering. Never partially raise or
lower antenna. Antenna must be raised
fully up into operating position or lowered
fully down into travel position.
TV SIGNAL AMPLIFIER
The TV signal amplifier is built into the
antenna and can be turned on or off with a power
switch on the video selection system (located on
a wall near the TV or in the entertainment center
cabinet, depending on model).
An indicator light will glow when the switch
is on and the signal amplifier is active.
TV Signal Amplifier Switch on
Video Selection System
Checking Amplifier Performance
The TV signals available to an RV are entirely
dependent on its location in relation to the
transmitter (tower). Signals may vary from
strong to no usable signal at all. We recommend
that the TV system be checked out in an area
known to have good TV reception.
To check the antenna amplifier, raise the
antenna, select a TV channel, and rotate the
antenna for best picture. Then turn off the
amplifier power switch. If the antenna amplifier
is working properly, the TV picture will now be
degraded (snowy). When you turn the switch
back on, the picture should again be sharp.
CABLE TV HOOK-UP
A cable television connector is provided and is
located in the utility compartment.
Cable TV Hook-Up
(Located in Utility Compartment)
-Typical View
EXTERIOR CABLE TV - 12V
CONNECTION
–If Equipped
The exterior cable TV/12-volt connection
receptacle on your coach provides connection for
use of a TV and/or 12-volt device for your
outdoor entertainment.
Exterior Cable TV / 12-Volt Connection
(Located near entrance door)
SECTION 8 –
ENTERTAINMENT
8-7
Advertisement
Table of Contents
