Winnebago Impulse User Manual page 75

Set Up Winterization Valves
1. Turn water heater bypass valve to BYPASS
position. (See "Water System Drain Valve
Locations" chart at end of this section for
location of bypass valve on your model).
2. Remove and save the protective cap from the
end of the antifreeze siphon tube (save cap to
cover tube after use). Insert the end of the tube
into a pail or other container with 2 to 3
gallons of non-toxic RV antifreeze solution.
3.
RV Antifreeze Siphon Tube and
Winterization Valve
-Typical View
(See Drain Valve Location chart at end of this
section for valve locations on your model)
4. Turn the Winterization Valve handle so that it
points toward the siphon tube. (See "Water
System Drain Valve Locations" chart at end of
this section for location of winterization valve
on your model).
Fill Lines
5. Turn the water pump switch ON.
6. Open each hot and cold water faucet handle/
knob in the coach – one at a time each in turn
until antifreeze solution just begins to flow
from the faucet, then close.
Do not forget exterior shower/wash station
knobs (if equipped).
7. Press the toilet flush pedal and hold until
When Done Adding RV Antifreeze
8. Turn water pump switch OFF.
9. Turn the Winterization Valve handle so it
10. Replace the protective cap onto the end of the
Siphon Tube
• (insert into
container of
RV water
Drain Water Heater
system
11. Turn off the water heater power switch before
antifreeze
Winterization
Valve
• (point toward
siphon tube for
winterizing)
antifreeze begins flowing into the toilet.
Leave small amount of antifreeze that remains
in the bowl.
points toward the waterline to the pump. This
will stop the flow from the antifreeze siphon
tube and revert the tank line flow to the pump.
antifreeze siphon tube to keep out insects or
debris when not in use.
draining the water heater tank to avoid
damage to the heating element.
• Drain the water heater by removing the plug
from the base of the water heater tank,
accessible from the outside of the coach.
(Requires socket and ratchet).
Water Heater Drain Plug
(Remove with socket)
• Also open the Pressure-Temperature Relief
Valve at the top right portion of the tank to
prevent air locking in the tank while
draining.
SECTION 7 –
PLUMBING
7-13