Video Loop Through; Video Out; Rs232 Port; Factory Reset Switch - PACOM 4-channel digital video recorder User Manual

User's Manual

Video Loop Through

NOTE: The Loop BNC connectors are auto terminated. Do NOT connect a cable to the Loop BNC
unless it is connected to a terminated device because it will cause poor quality video.

Video Out

NOTE: It is possible that the DVR does not detect a VGA monitor automatically if the connected VGA
monitor does not support auto detect function. In this case, press and hold the
front panel for 5 seconds or longer to switch the video output to VGA out. Pressing and holding the
button for 5 seconds or longer again returns to the previous video output mode.
PANIC

RS232 Port

An RS232 port is provided to connect a remote control keyboard.

Factory Reset Switch

The DVR has a Factory Reset switch to the left of the Alarm Output connectors on the
rear panel. This switch will only be used on the rare occasions that you want to return
all the settings to the original factory settings.
CAUTION: When using the Factory Reset, you will lose any settings you have saved.
To reset the unit, you will need a straightened paperclip:
1. Turn the DVR off.
2. Poke the straightened paperclip to the unlabeled hole in the left of the Alarm Output connectors, and
turn the DVR on.
3. Hold the reset switch until the DVR turns on and live monitoring screen appears.
4. Release the reset switch. All of the DVR's settings are now at the original settings it had when it
left the factory.

Alarm Input/Output

4
If you would like to connect your video source to another device, you can use
the Loop BNC connectors.
A VGA connector is provided so that you can use a standard, multi-sync computer
monitor as your main monitor. Use the cable supplied with your monitor to connect
it to the DVR. The VGA monitor is automatically detected when you connect it
Connect the main monitor to the Video Out connector
NOTE: To make connections on the Alarm Connector Strip, press and
hold the button and insert the wire in the hole below the button. After
releasing the button, tug gently on the wire to make certain it is connected.
To disconnect a wire, press and hold the button above the wire and pull
out the wire.
.
button on the
PANIC
.