Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for PACOM PDR420
Summary of Contents for PACOM PDR420
-
Page 3: Compliance Notice Of Fcc
Four-Channel Digital Video Recorder WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage"... -
Page 4: Important Safeguards
User’ s Manual Important Safeguards 1. Read Instructions 13. Damage requiring Service All the safety and operating instructions should be read before the Unplug this equipment from the wall outlet and refer servicing to appliance is operated. qualified service personnel under the following conditions: A. -
Page 5: Table Of Contents
Four-Channel Digital Video Recorder Table of Contents Chapter 1 — Introduction..............1 Features ..................1 Package Contents ................1 Rear Panel Connectors ..............2 Factory Reset................. 3 Front Panel Controls ..............3 Chapter 2 — Operation..............4 Turning on the Power ..............4 Live Viewing ................... - Page 6 User’ s Manual...
-
Page 7: Chapter 1 - Introduction
Four-Channel Digital Video Recorder Chapter 1 — Introduction FEATURES Your color digital video recorder (DVR) provides recording capabilities for 4 camera inputs. It provides exceptional picture quality in both live and playback modes, and offers the following features: Ÿ 4 Composite Input Connectors Ÿ... -
Page 8: Rear Panel Connectors
User’ s Manual REAR PANEL CONNECTORS No special tools are required to install the DVR. Refer to the installation manuals for the other items that make up part of your system. Your DVR should be completely installed before proceeding. Video In: Connect the coaxial cables from the video sources. Network: Connect a Cat5 cable with an RJ-45 jack. -
Page 9: Factory Reset
Four-Channel Digital Video Recorder FACTORY RESET To reset the unit, you will need a straightened paperclip: 1. Turn the DVR off. 2. Turn it on again. 3. While the DVR is initializing, poke the straightened paperclip in the unlabeled hole to the right of the RS-485 connector. -
Page 10: Chapter 2 - Operation
User’ s Manual Chapter 2 — Operation TURNING ON THE POWER Connecting the power cord to the DVR turns on the unit. The unit will take approximately 60 seconds to initialize. The DVR provides five operation modes: live viewing, recording, playback, searching and PTZ mode. When the DVR operates first, it displays quad screen and starts recording. -
Page 11: Live Viewing
Four-Channel Digital Video Recorder LIVE VIEWING To Change Screen Mode Ÿ Full-screen Pressing a camera button in quad screen mode displays that camera in full screen. Ÿ Quad screen Pressing the DISPLAY button in full screen mode displays four cameras at once. -
Page 12: Playback
User’ s Manual To Enter Recording Mode Schedule recording (Main Menu à Schedule) Ÿ On: Enables schedule recording. Setup: Sets up the recording mode for each hour. C (Continuous Record: Records continuously.) E (Event Record: Records when detecting events.) - (Off: Does not record.) Ÿ... -
Page 13: Searching
Four-Channel Digital Video Recorder SEARCHING The DVR provides various search engines: Date/Time, Calendar and Event, and also supports clip copying a video segment. To Enter Searching Mode Pressing the MENU button in playback mode enters Search mode and displays the Search Menu. Select the desired search mode in the search menu. -
Page 14: Ptz Control
User’ s Manual PTZ CONTROL PTZ control is available for only PTZ cameras that allow pan, tilt, zoom, focus or preset etc. To Enter PTZ Mode Connect a PTZ device to the DVR and select the PTZ model at Main Menu à Advanced Setup à... - Page 15 Four-Channel Digital Video Recorder To Run Preset Pressing the MENU button in PTZ mode displays the PTZ menu. Move to SET PRESET in the PTZ menu and select it by pressing button. Pressing the button displays the preset name box. Pressing the button again displays a virtual keyboard.
-
Page 16: Chapter 3 - Configuration
User’ s Manual Chapter 3 — Configuration OVERVIEW How to Enter Main Setup Menu Pressing the MENU button in live-viewing mode enters a Main Setup menu. Entering a Main Setup menu is password protected. Enter the password by pressing the camera buttons 1 to 4, and a Main Setup screen appears. -
Page 17: Main Setup
Four-Channel Digital Video Recorder How to Enter Characters Select the desired item and press button, and a virtual keyboard displays. Move to the desired character by pressing the arrow buttons, and enter the selected character by pressing the button. Pressing the OK button saves the characters you entered. - Page 18 User’ s Manual NOTES: Ÿ Schedule recording and Manual recording work independently each other. Ÿ Refer to the following Advanced Setup section for the further information on setting event recording. Record Quality/Speed Ÿ Record Quality: Sets the same record quality for all camera channels. Ÿ...
- Page 19 Four-Channel Digital Video Recorder Network Setup Ÿ Type Manual: When using a static IP address for network connection, select Manual, and enter the network parameters manually. DHCP: When the DVR is networked through DHCP, select DHCP. The DVR reads the IP address from DHCP (Dynamic Host Configuration Protocol) network.
- Page 20 User’ s Manual System Information Ÿ System Version: Displays the system version. Language: Displays the system language. Ÿ Upgrade: Connecting the USB flash drive containing the upgrade package file (.rui) to the USB port on the front panel and selecting the desired file upgrades the software. Ÿ...
-
Page 21: Appendix
Four-Channel Digital Video Recorder Appendix WEBGUARD WebGuard allows you to access a remote DVR, monitor live video images and search recorded video using Internet Explorer web browser anytime from virtually anywhere. Computer system requirements for using the WebGuard program are: ®... - Page 22 User’ s Manual Web Monitoring Mode The WebWatch is a remote web monitoring program that allows you to monitor live video transmitted in real-time from the remote DVR. Log Out: Click the to log out the WebGuard program. WebSearch: Click the to access to the web search mode.
- Page 23 Four-Channel Digital Video Recorder Web Search Mode The WebSearch is a remote web search program that allows you to search recorded video on the remote DVR. Log Out: Click the to log out the WebGuard program. WebWatch: Click the to access to the web monitoring mode. WebSearch Logo: Position the mouse pointer on the logo to see the version of the WebGuard program.
-
Page 24: Minibank Self Player
User’ s Manual NOTES: Ÿ Image processing works only in the pause mode. MINIBANK SELF PLAYER Disconnect the USB flash drive from the DVR and connect it to your PC. You do not need to install any special software on your personal computer to review the video. The copied clip contains the Player program. Double click the target clip to start the Player program. -
Page 25: Factory Default Settings
Four-Channel Digital Video Recorder Mute Button: Click to mute the recorded audio. Brightness Revert Button: Click to reload to the original image. Brightness Control Slide Bar: Click to adjust the brightness of the backup images by clicking the mouse and dragging along the slider bar. Minute brightness changes can be made by using the arrow buttons located at each end of the bar. -
Page 26: System Log
User’ s Manual SYSTEM LOG LOG MESSAGE DESCRIPTION LOGIN (L) System login from the local site. LOGOUT (L) System logout from the local site. LOGIN (W) System login from the remote site (WebWatch). LOGOUT (W) System logout from the remote site (WebWatch). LOGIN (S) System login from the remote site (WebSearch). -
Page 27: Troubleshooting
Four-Channel Digital Video Recorder TROUBLESHOOTING PROBLEM POSSIBLE SOLUTION Ÿ Check power cord connections. No Power Ÿ Confirm that there is power at the outlet. Ÿ Check camera video cable and connections. Ÿ Check monitor video cable and connections. No Live Video Ÿ... -
Page 28: Specifications
User’ s Manual SPECIFICATIONS VIDEO Signal Format NTSC or PAL (auto detect) Video Input Composite: 4 looping inputs, 1 Vp-p, auto-terminating, 75 Ohms Monitor Outputs Composite: One (BNC), 1 Vp-p, 75 Ohms Video Resolution 720x480 (NTSC), 720x576 (PAL) Playback/Record Speed 30ips (NTSC), 25ips (PAL) (images per second) INPUTS/OUTPUTS... - Page 29 WEEE (Waste Electrical & Electronic Equipment) Correct Disposal of This Product (Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or its literature, indicates that it should not be disposed with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources.