Chapter 2 — Installation
Package Contents
The package contains the following:
Digital Video Recorder
Power Cord
User's Manual (This Document)
RAS Software CD and User's Manual
Rack-mount Kit
Assembly Screws for Adding Hard Disk Drives
SATA Cables
Infrared Remote Control
Required Installation Tools
No special tools are required to install the DVR. Refer to the installation manuals for the other items that make up part
of your system.
Video Input
Alarm Input/Output
Video Out
Your DVR can be used with either NTSC or PAL equipment.
NOTE: You cannot mix NTSC and PAL equipment. For example you cannot use a PAL camera and an NTSC
monitor.
Video Input
Connect the coaxial cables from the video sources to the BNC Video In connectors.
Video Loop Through
If you would like to connect your video source to another device, you can use the Loop BNC connectors.
Figure 2: 16-Channel DVR rear panel.
Video Loop Through
RS485 Port
Network Port
Audio In/Out
eSATA Port
RS232 Port
Factory Reset Switch
Power Cord Connector
Digital Video Recorder
3