Network Led; Clip Copy Led; Power Led; Panic Button - PACOM 4-channel digital video recorder User Manual

User's Manual

Network LED

The Network LED is lit when the unit is connected to a network via Ethernet.

Clip Copy LED

The Clip Copy LED is lit when the DVR is clip-copying.

Power LED

The Power LED is lit when the unit is On.

PANIC Button

Pressing the button starts panic recoding of all camera channels, and displays on the screen. Pressing
PANIC
the button again will stop panic recording.
NOTE: When the DVR does not detect a VGA monitor automatically, pressing and holding the
PANIC
button on the front panel for 5 seconds or longer switches the video output to VGA out manually.

ALARM Button

The button has two functions. First, it will reset the DVR's outputs including the internal buzzer
ALARM
during an alarm. Second, it will display the event log when you are in the live monitoring mode unless there
is an active alarm. This operation can be user password protected. The button is also used to load a Preset
View in the PTZ mode.

CLIP COPY Button

Pressing the button allows you to copy video clips. This button is also used to save Presets in
CLIP COPY
the PTZ mode.

ZOOM Button

In the live monitoring mode, pressing the button enters the Zoom mode, and pressing the button again
ZOOM
exits the zoom mode. When in the zoom mode, a rectangle displays on the screen. A rectangle shows the area
that will be enlarged. You can move the rectangle around using the arrow buttons. Pressing the (Play/Pause)
button in enlarges the area in rectangle.

DISPLAY/SEQUENCE Button

The button toggles between quad (2x2) display mode and sequence mode.
DISPLAY/SEQUENCE

PTZ Button

In the live monitoring mode, pressing the button enters the PTZ mode, and pressing the button again
PTZ
exits the PTZ mode. When in the PTZ mode, pressing the arrow buttons or button allows you to
MENU
control properly configured cameras.
8