Chapter 2 ─ Installation; Package Contents; Required Installation Tools; Video Input - PACOM PDRH-440 User Manual

Chapter 2 ─ Installation

Package Contents

The package contains the following:
 Digital Video Recorder
 Power Cord
 User's Manual (This Document)
 RAS Software CD and User's Manual
 Infrared Remote Control

Required Installation Tools

No special tools are required to install the DVR. Refer to the installation manuals for the other items that make up
part of your system.

Video Input

RS232 Port
Factory Reset Switch
Power Cord Connector
Your DVR can be used with either NTSC or PAL equipment.
NOTE: You cannot mix NTSC and PAL equipment. For example you cannot use a PAL camera and an NTSC
monitor.
Video Input

Video Loop Through

NOTE: The Loop BNC connectors are auto terminated. Do NOT connect a cable to the Loop BNC unless it is
connected to a terminated device because it will cause poor quality video.
Figure 2 ─ DVR rear panel.
Connect the coaxial cables from the video sources to the BNC Video In connectors.
If you would like to connect your video source to another device, you can use the Loop
BNC connectors.
Video Loop Through
Alarm Input/Output
Network Port
4-Channel Digital Video Recorder
Video Out
RS485 Port
Audio In/Out
3