ESP CanCam User Manual page 18

CanCam Manual_Layout 5 05/09/2013 12:22 Page 18
To Capture Videos, make sure display reads VIDEO:
• Once in CAM mode, if the display does not read VIDEO then,
• Press the [M] button once.
• If the LCD display does not show word VIDEO in blinking.
• Press the [UP] button ONCE to toggle to Video mode.
• Press the [OK] button and then [M] Button to exit.
• 30 seconds after making adjustments, the laser beam will begin blinking and enter
the countdown mode.
• After one minute, the camera will enter either Burst mode or Video mode based on
the programmed settings. The cameras will then time out between 05-59 seconds
or 1-59 minutes depending on the programmed setting.
NOTE: The time between motion detection and the camera taking the pictures may
vary due to lighting conditions, program settings, and battery power level.
Using The Camera In Time Lapse Mode
• Open the bottom housing and slide the switch to CAM mode. At this point, you have
30 seconds to make any mode selection changes before camera is ready to use.
• Make sure your camera is in Time Lapse (TLS) mode and not PIR mode. If your not
sure, please follow the "Camera setup and program" above to set the camera into
TLS mode.
• 30 seconds after making adjustments, the laser beam will begin blinking and enter
countdown mode. This is your indication to leave the coverage area within one
minute, then the camera will enter Time Lapse Mode.
Deleting files on the Camera
• Slide the switch the CAM position.
• LCD screen will display the camera status screen.
• Press the [M] button within 30 seconds to enter the programming mode.
• Press the [DN] button until you see the word - dEL - in blinking on LCD display.
• Press [OK] button to enter the DELETE & FORMAT menu.
• Press [UP] or [DN] button to select the desired function.
– NO-dL (No Delete) - No images get deleted.
– d-ONE (Delete One) - Only the last file will get deleted.
– d-ALL (Delete ALL) - Deletes ALL images on the SD card.
– Ft (Format) - Deletes all files and reformats the SD card.
• Press [OK] to confirm your selection.
• Press [M] button to exit the program setting and back to the status screen.
18