ESP CanCam User Manual page 16

CanCam Manual_Layout 5 05/09/2013 12:22 Page 16
• Press [UP] or [DN] to increase or decrease the Month value (1 - 12).
• Press [OK] to save your selection and enter Day setting.
• The DAY digits will be blinking.
• Press [UP] or [DN] to increase or decrease the Day value (01 – 31).
• Press [OK] to confirm the Date setting and enter Year setting.
• The YEAR digits will be blinking.
• Press [UP] or [DN] to increase or decrease the Year value (01 – 99).
• Once this is all done, press [OK]. You'll then see the word - dEL - blinking.
• Press [M] button to exit the program setting and back to the status screen.
Setting the Time Lapse Mode:
The Time Lapse default setting value is from 17:00 to 07:00 the next day. When
the camera is set to use the Time-Lapse mode (TLS), the program settings will
follow the Time Lapse settings. Outside of the Time Lapse time frame; the camera
will follow the user defined PIR settings.
The user can set the program for a pre-determined time period [such as 19:00 to
07:00]. The user then sets the frequency of still images only (video function not
available in Time Lapse mode). The camera will remain in Time Lapse mode until
the user has changed the program setting.
• Slide the switch to the CAM position, LCD display
will show the camera status screen.
• Press the [M] button once within 30 seconds to
enter the programming mode, the word PIR or TLS
will be blinking.
• Press [UP] button until you see the word TLS
blinking.
• Press [OK] to confirm and go into TLS Mode "Start
Time" setting.
• The display will show T + S-88:88 (S = Start,
88:88 = time in HH:MM).
• Press [OK] to set the "Start Time" setting. At this
point you can adjust the time from 00:00 to 23:59.
• The MINUTE digits will be blinking.
• Press [UP] or [DN] to increase or decrease the
minute value (00 – 59).
• Press [OK] to save your selection and enter Hour
setting.
• The HOUR digits will be blinking.
16