ESP CanCam User Manual page 17

CanCam Manual_Layout 5 05/09/2013 12:22 Page 17
• Press [UP] or [DN] to increase or decrease the hour value (00 – 23).
• Press [OK] to save the "Start Time" setting and move to the "End Time" setting.
• After completing the start time setting, camera will go into TLS Mode "End
Time" setting.
• The display will show T + E-88:88
• (E = End, 88:88 = time in HH:MM)
• At this point you can adjust the time from 00:00 to 23:59 by pressing the
[UP/DN/OK] buttons same as Start Time settings.
• Press [OK] to save the "End Time" settings and move directly to the TIME OUT
setting.
• Please complete the TIME OUT, Still Image Resolution, Burst Mode, Zoom
settings like the settings on the PIR operation mode.
• Then press [M] button to exit.
EXAMPLE:
1 – If a user selected the Time Lapse mode, and sets the Start Time to 07:00
and End Time at 20:30, then selects the Timeout to be 3mins with a Burst
mode of 3 pictures, this means that the camera will keep taking 3 pictures
for every 3 minutes within the time frame of 7:00AM to 8:30PM. When not
within the Time Lapse time frame, the camera will follow the normal PIR
detection settings.
2 – If a user selected the Time Lapse mode setting as Start Time 00:00 and End
Time 00:00, then selected the Timeout to be 5mins with a Burst mode of
3 pictures, this means the camera will keep taking 3 pictures for every 5
minutes, 24 hours a day non-stop.
Using The Camera in PIR Detection Mode
• Open the bottom housing and slide the switch to either one of the CAM or PSET
modes. At this point, you have 30 seconds to make any mode selection changes
before camera is ready to use.
• If you chose CAM mode then make sure your camera is in the PIR mode and not
Time Lapse (TLS). If you are not sure, please follow the "Camera setup and
program" above to set the camera into the proper mode.
To Capture Images, make sure display reads CAM:
Once in CAM mode, if the display does not read CAM then,
• Press the [M] button once.
• If the LCD display does not show word CAM in blinking.
• Press the [UP] button ONCE to toggle to Camera mode.
• Press the [OK] button and then [M] Button to exit.
17