ESP CanCam Quick Manual Setup

1
Insert batteries
• Unscrew the top lid of the
CanCam to access the
battery compartment
• Install 4 "C" cell batteries
with the correct polarity (+/-)
as indicated in the battery
compartment
• Screw the lid back on using
the guidance notch on the lid
to secure correctly
3
Set the time and date
• Turn the switch to CAM to
adjust the time and date
setting
• After the initial test display,
the internal LCD screen will
display a blinking 'T' and the
default time
• Press the [OK] button to start the time settings
• Press the [UP] or [DN] button
to adjust the Minute setting
and press [OK] to confirm
• Press the [UP] or [DN] button
to adjust the Hour setting
press [OK] to confirm
Q U I C K G U I D E S E T U P
2
• Unscrew the bottom of the
CanCam to access the LCD,
ports and controls
• Insert the SD card into the SD card slot
• The next display shows the default date
• Adjust the Month using [UP]
or [DN] button and press [OK]
• Adjust the Day using [UP] or
[DN] button and press [OK]
• Adjust the Year using [UP] or
[DN] button and press [OK]
• Once complete, the word - dEL - will flash, this allows
the SD Card to format
• Press [OK] then press [DN] and press [OK].
SD card is now formatted
• Press the [M] button to exit time and date setting
Load SD Card