ESP CanCam User Manual page 15

CanCam Manual_Layout 5 05/09/2013 12:22 Page 15
Setting the Time Out in PIR mode:
The CanCam can be programmed to set the amount of time in seconds or minutes
the camera will sleep between PIR triggers.
• Slide the switch to the CAM position, LCD display will show the camera status
screen.
• Press the [M] button once within 30 seconds to enter the programming mode.
• The word PIR will be blinking, press [OK] to confirm the camera's operation is
PIR detection.
• Press [UP] or [DN] button until the word T-O (Time Out) is blinking.
• Press [OK] button and the MINUTES digits will be blinking.
• Press [UP] or [DN] button to increase or decrease the time value in minutes
from 00 to 10 minutes in 1-minute increments.
• Press [OK] to save the minute setting and the SECONDS digits will be blinking.
• Press [UP] or [DN] button to increase or decrease the time value in seconds
from 01 to 55 seconds in 5-second increments.
• Press [OK] to save the second setting.
• The letter T (Time) will be blinking. Press [OK] button to enter time setting or
press [M] button to exit.
Setting the Time and Date in PIR operation mode:
The CanCam uses the 24hr time format.
• Slide the switch to the CAM position, LCD display will show the camera status
screen.
• Press the [M] button once within 30 seconds to enter the programming mode.
• The word PIR will be blinking, press [OK] to confirm the camera's operation is
PIR detection.
• Press [UP] or [DN] button until the letter T is blinking.
• Press [OK] to enter Minute setting first.
• The MINUTE digits will be blinking.
• Press [UP] or [DN] to increase or decrease the minute value (00 – 59).
• Press [OK] to save your selection and enter Hour setting.
• The HOUR digits will be blinking.
• Press [UP] or [DN] to increase or decrease the hour value (00 – 23).
• Press [OK] to save your selection and enter Month setting.
• The MONTH digits will be blinking.
15